Later, I helped a friend disassemble a Tesla model, and the mass of circuit boards inside was overwhelming—until I drew 5 diagrams that clarified how the motor controller works. Honestly, even friends ...

They’ve taken the field-oriented control algorithm and encapsulated it into a compact Arduino library, added a host of examples, and minted a stackable BLDC motor control shield to boot.

An Arduino-based cnc controller for separate stepper drivers? grbl is stepper motor controller firmware for three-axis cnc machines, intended to run on Arduinos with a motor driver add-on board.

Here is a tested Arduino project that uses 3 sensor probes as water level indicator with 3 leds and one LCD display + a simple controller that turns on a motor when the water has reached the desired ...

As the valves use 24V and the motor 12V, standard N-Mosfets and power relays are used for voltage conversion. The remote controller [Gilard] used is actually 20 years old, so the output signal of ...

Makers, electronic enthusiasts and those interested in building robots may be interested in a new robotic arm project featured ...

After purchasing the Qu4tro electric skateboard and finding the controller wasn’t quite as good as the skateboard, Timo Brinschein decided to build his very own using a little Arduino hardware ...

A teacher I know is stuck, with only npn transistors in the supply cupboard and the need to create a reversible motor drive for an Arduino project. Reversing ‘bridges’ have four switches (relay ...